English Chinese (Simplified)

comatrol hydraulic cartridge valves



Dual counterbalance HIC, 10-size, hydraulic vent with make-up checks. This is an internally piloted, low leakage assembly. The DCB10-MC uses two CB10-HV cartridges and four CP100-3 check valves, allowing free flow from the V port to the C ports and blocks flow in the reverse direction until the relief setting is reached, or until adequate pilot pressure has been applied to the opposite V port. Connect the T port to a tank line to allow for make-up flow into the circuit.



Dual counterbalance HIC’s are used for controlling loads in bidirectional motion such as wheel motor applications or for cylinders going over center. They are also suitable for use on the boom and dipper cylinder on an excavator. When make-up feature is needed, connect ‘T’ port to reservoir or charge system. This allows the load to be smoothly controlled with minimum energy loss. If load tries to run ahead of pump, pilot pressure will decrease and the relief section will throttle or close to prevent runaway. The T port is also useful in cylinder applications where directional valves (specifically proportional valves) are sensitive to flow intensification of powering the rod side. The DCB10-MC diverts flow directly to tank and bypasses the directional valve. This HIC technically replaces the 1EEC11-01.




Rated Presssure        315 bar [5075 psi]*
Rated Flow at 22 bar
[319 psi]
57 l/min
[15 US gal/min]    

  2.39 kg [5.27 lb], Aluminum
5.04 kg [11.11 lb], Ductile

Pilot Ratio   3.0:1, 4.5:1, 10.0:1
Cavity   CIB


Performance Curve







Example Circuits




Ordering Information



Product Documents and Downloads
Download this file (DCB10-MC Catalog Pages.pdf)DCB10-MC Catalog Pages.pdf1969 kB04-28-2015

Counterbalance Valves

© Comatrol 2018 | All rights reserved

  Facebook      Twitter     linkedin Linked-In     youtube YouTube  Privacy Policy    Term of Use


Danfoss Power Solutions S.r.l. IT07874070019